Straight from the Source
Navigation

Poly-WB+ Polyurethane Sealer

Price range: $90.93 through $97.93

HIGHLIGHTS:

  • Good Pot-life – 2 hours at 75°F / 50% Humidity
  • Ultra Violet light stable
  • Very Good Stain & Chemical Resistance
  • High Performance – Much more durable than traditional solvent-based Acrylic Sealers
  • Easy to Clean & Maintain
  • Wet Look – Enhances Colors
  • Non-Blushing
  • Dries Clear
    • Solid Colors  possible with the addition of Smith’s WSC Waterborne Solid Color Packs (Sold Separately)
  • Hot Tire Pickup Resistant
  • Low VOC’s – Meets Source Specific Standards Rule 1113 established by AQMD in California
12 months with 0% interest for qualified customers on equipment purchases of $10,000 or more.

Description

Smith’s Poly-WB+ is a 2-component, high performance, waterborne, Aliphatic Polyurethane sealer / topcoat which yields a hard, durable protective wear surface for use over decorative concrete or resinous floor coatings in commercial or residential environments with mild to heavy foot traffic exposure as well as residential garage floors.

Developed for interior or exterior wear surfaces to protect against staining, chemicals, long-term chalking in Ultra Violet light exposure environments. Direct-to-concrete, stone & paver applications require a primer of Smith’s Poly-SB (achieves wet look); Smith’s Poly-SEAL (natural appearance without color enhancement); Smith’s Epoxy FW38 (interior only priming Grind & Seal applications) or directly over Smith’s Color Floor stains.

Available in either a High Gloss or Matte finish. Both finishes achieve a wet-look to boost color & depth of stains when applied as a clear topcoat over Smith’s Color Floor or Smith’s Color Wall stains. For solid colors, optional Smith’s WSC Color Packs are available separately.

RECOMMENDED AS A FINAL TOPCOAT FOR:

Commercial & Residential:

  • Decorative & Stamped Concrete
  • Concrete Countertops
  • Terrazzo
  • Sealer for Vinyl Chip resinous coating systems
  • Metallic epoxy topcoat
  • Pavers

HIGHLIGHTS:

  • Good Pot-life
    • 1 hour at 72°F / 50% Humidity
  • U.V. Stable
    • Poly-WB+ does not chalk nor yellow
  • Abrasion, stain & chemical resistant
  • Superior performance vs. traditional solvent-based acrylic sealers
  • User friendly to mix & apply
    • Conveniently mix in packaging when mixing entire kit
    • Yields a more desirable appearance less prone to roller lines than typical 2-component waterbased Polyurethanes
  • Easy to clean & maintain
  • “Wet Look” color enhancement of stained concrete
  • Non-Blushing
  • Applies Milky but dries Clear
  • Hot tire pick up resistant
  • Low VOC’s & Low Odor – Meets Source Specific Standards Rule 1113 established by AQMD in California

Additional information

Finish

High Gloss, Low Sheen

Documents

Poly-WB Plus Gloss

Poly-WB Plus Low Sheen

SDS – Part A – Smith’s Poly WB+ Gloss

SDS – Part B – Smith’s Poly WB+ Gloss

SDS – Part A – Smith’s Poly WB+ Low Sheen

SDS – Part B – Smith’s Poly WB+ Low Sheen